Board of Directors
National Massey Collectors Association
Indiana Massey Collectors Association
Missouri Massey Collectors Association
Massey Collectors of Illinois #3
Massey Harris Ferguson Club of Ohio
Friends of Massey
Massey Family Collectors of Wisconsin
Iowa Massey Collectors Association
Illinois Massey Collector #8
333 Diesel Injection Pump Question
Massey Days Reunion June 11th - 13t...
Gene Besonson Estate Auction June 2...
MH 44 rear end assembly
Massey Harris Valve 333/444/555
Massey Harris Semi-Mounted NO. 6 M...
Active participation in the Discussion Forum requires a currently paid membership to the MCA or one of its local Chapters. Contact your
Discuss Massey related topics, Q&A, mechanical problems, etc.
Subscribe to post
(11/11/2013 5:04:51 PM)
RE:Massey 44 Special rearend seal replacement help
I just repaired mine last week so it is still fresh in my head. Pull the outer cover off and there will be a snap ring on the inner shaft, Remove it and you can pull the gear off. There are threaded holes in the gear if you need a puller to get it off. Next if you look down the shaft there is a larger snap ring holding the pto cluth in place. Do not remove the bolts around the outside of the clutch or there will be balls and springs falling everywhere. The pto clutch should pull off the shaft once the snap ring is removed,(and live pto linkage) but if everything is full of oil, grease, brake dust..... this may take some effort. Again there is a snap ring holding the brakes in place. Remove the snap ring and brake assembly( after removing the brake linkage). Drain the oil out of the trans/rear axle. Now you can pull the nuts holding the remaining bracket that held the brake assembly. There are 2 seals on the back side of the bracket. The remaining outer shaft should pull out and there is another seal in that also. I hope this helps, I couldn,t find any service info on this either. I also had to take the pto clutch apart to clean the oil off the disks and rough them up a little with a scuff pad.I got the seals from Kessels massey parts and they were an exact fit. Any questions call Todd at 920 849-7388
Powered by Kentico CMS for ASP.NET