Board of Directors
National Massey Collectors Association
Indiana Massey Collectors Association
Missouri Massey Collectors Association
Massey Collectors of Illinois
Massey Harris Ferguson Club of Ohio
Friends of Massey
Massey Family Collectors of Wisconsin
Iowa Massey Collectors Association
MF 2135 Industrial for sale
Looking for Rod Bearings for 333 Di...
Wide axle 44
135 keyless ignition switch
Massey Harris General Purpose Four ...
2014 Ohio Massey & Ferguson Sho...
Active participation in the Discussion Forum requires a currently paid membership to the MCA or one of its local Chapters. Contact your
Discuss Massey related topics, Q&A, mechanical problems, etc.
Subscribe to post
(1/14/2013 10:06:53 PM)
RE:New Years Day Start up and Road Run.
I made this puller when I was trying to get the wheels off the Cub jr, I was thinking I was never going to get them off. The piece of steel I was using was geting well hammered and I had used plenty of HEAT to, then had the idea of the spring steel,to hard to drill so had to make holes with cutting torch. When I tried again I found every time I hit it with the hammer the bolt would tighten a little eventualy the wheels came off and I have never used heat since.
Powered by Kentico CMS for ASP.NET