Board of Directors
National Massey Collectors Association
Indiana Massey Collectors Association
Missouri Massey Collectors Association
Massey Collectors of Illinois
Massey Harris Ferguson Club of Ohio
Friends of Massey
Massey Family Collectors of Wisconsin
Iowa Massey Collectors Association
Cast Iron M-H Memorabilia
Stationary Massey Harris Engines
Massey mens' food!
Massey Feature at Heritage Park For...
Hauling Wanted: Winnipeg,Manitoba t...
MH 44 wide front and 3 point for sa...
Active participation in the Discussion Forum requires a currently paid membership to the MCA or one of its local Chapters. Contact your
Discuss Massey related topics, Q&A, mechanical problems, etc.
Subscribe to post
(5/18/2012 8:41:18 AM)
RE:tractor design faults
I haven't had that particular problem but last year I had terribe grief with my red MH 25 rear wheels. It had been fitted with cut down spokes and rubber rims and I wanted them off to fit original spoke rubber rims.
After many days of fighting with heat and various pullers including an official MH one I gave up the fight when a 60 ton puller I borrowed from a large truck repair shop failed miserably.
it was then a mattter of cut the rim off by the spokes, then cut through the hub with a large cutting wheel. This cutter wouldn't quite reach through right to the base of the back of the hub but we were 95% through and it split with a chisel and fell off as if laughing at us. Both sides were the same.
I would have thought it might have been possible to have the hub be a slip fit back to a small butt rim on the axle leaving the wodruuf key to tighten the whole affair up and the nut to fix it on.
Also, the nuts would not turn off - unbelievably tight and I had to split these off and have new ones made.
I've heard of others having similar problems with the taper axle shafts but I think mine was perhaps an extreme case
One of the beaten offenders attached!!
Powered by Kentico CMS for ASP.NET