Board of Directors
National Massey Collectors Association
Indiana Massey Collectors Association
Missouri Massey Collectors Association
Massey Collectors of Illinois #3
Massey Harris Ferguson Club of Ohio
Friends of Massey
Massey Family Collectors of Wisconsin
Iowa Massey Collectors Association
Illinois Massey Collector #8
Needed: Diesel shut down push/pull...
Massey Harris Colt with Half Tracks
Old Timers still at it!
Massey Days Reunion UPDATE
Massey Days Quilts are done!!
Active participation in the Discussion Forum requires a currently paid membership to the MCA or one of its local Chapters. Contact your
Discuss Massey related topics, Q&A, mechanical problems, etc.
Subscribe to post
(5/18/2012 8:41:18 AM)
RE:tractor design faults
I haven't had that particular problem but last year I had terribe grief with my red MH 25 rear wheels. It had been fitted with cut down spokes and rubber rims and I wanted them off to fit original spoke rubber rims.
After many days of fighting with heat and various pullers including an official MH one I gave up the fight when a 60 ton puller I borrowed from a large truck repair shop failed miserably.
it was then a mattter of cut the rim off by the spokes, then cut through the hub with a large cutting wheel. This cutter wouldn't quite reach through right to the base of the back of the hub but we were 95% through and it split with a chisel and fell off as if laughing at us. Both sides were the same.
I would have thought it might have been possible to have the hub be a slip fit back to a small butt rim on the axle leaving the wodruuf key to tighten the whole affair up and the nut to fix it on.
Also, the nuts would not turn off - unbelievably tight and I had to split these off and have new ones made.
I've heard of others having similar problems with the taper axle shafts but I think mine was perhaps an extreme case
One of the beaten offenders attached!!
Powered by Kentico CMS for ASP.NET