Board of Directors
National Massey Collectors Association
Indiana Massey Collectors Association
Missouri Massey Collectors Association
Massey Collectors of Illinois #3
Massey Harris Ferguson Club of Ohio
Friends of Massey
Massey Family Collectors of Wisconsin
Iowa Massey Collectors Association
Illinois Massey Collector #8
Grandson learning to drive the Mass...
2015 MHFCO State Show at Plain City...
745 MH wheelbase
Active participation in the Discussion Forum requires a currently paid membership to the MCA or one of its local Chapters. Contact your
Discuss Massey related topics, Q&A, mechanical problems, etc.
Subscribe to post
(1/14/2013 10:06:53 PM)
RE:New Years Day Start up and Road Run.
I made this puller when I was trying to get the wheels off the Cub jr, I was thinking I was never going to get them off. The piece of steel I was using was geting well hammered and I had used plenty of HEAT to, then had the idea of the spring steel,to hard to drill so had to make holes with cutting torch. When I tried again I found every time I hit it with the hammer the bolt would tighten a little eventualy the wheels came off and I have never used heat since.
Powered by Kentico CMS for ASP.NET