Board of Directors
National Massey Collectors Association
Indiana Massey Collectors Association
Missouri Massey Collectors Association
Massey Collectors of Illinois
Massey Harris Ferguson Club of Ohio
Friends of Massey
Massey Family Collectors of Wisconsin
Iowa Massey Collectors Association
Looking for Rod Bearings for 333 Di...
135 keyless ignition switch
Massey Harris General Purpose Four ...
2014 Ohio Massey & Ferguson Sho...
2014 Trip to Huber Museum in Marion...
2014 Rushville MENA
Active participation in the Discussion Forum requires a currently paid membership to the MCA or one of its local Chapters. Contact your
Discuss Massey related topics, Q&A, mechanical problems, etc.
Subscribe to post
(1/26/2013 3:41:39 PM)
RE:Valve Spring Failure on Massey 25
Great to see you enjoying this 25 thread with added interest in your 25's.
If I was you I would rebuild that carburetor, the cast iron ones for the styled 25's and Pacemaker / Challengers are very hard to find, the air pipe end is made to take the rubber pipe connection. The brass Kingston's on the unstyled 25's are a lot more common. Find a brass one and swap the parts to your original cast iron carb, you can get new floats etc for the rebuild.
I was lucky to have a spare one on my shelf for this last styled 25 rebuild, it came from the same farm in Warwickshire as my styled 25 on F&H rubbers.
A good welder would also put you an end in your bottom oil filter, had some like that here too.
I enjoyed your green 25 story and it looks a very nice tractor.
Powered by Kentico CMS for ASP.NET