Board of Directors
National Massey Collectors Association
Indiana Massey Collectors Association
Missouri Massey Collectors Association
Massey Collectors of Illinois
Massey Harris Ferguson Club of Ohio
Friends of Massey
Massey Family Collectors of Wisconsin
Iowa Massey Collectors Association
Looking for Rod Bearings for 333 Di...
Wide axle 44
135 keyless ignition switch
Massey Harris General Purpose Four ...
2014 Ohio Massey & Ferguson Sho...
2014 Trip to Huber Museum in Marion...
Active participation in the Discussion Forum requires a currently paid membership to the MCA or one of its local Chapters. Contact your
Discuss Massey related topics, Q&A, mechanical problems, etc.
Subscribe to post
(8/5/2012 6:13:40 PM)
I wanted to give an update on my most recent Wallis project. I posted earlier about the rebuilt head for our OK. Well finally this weekend I managed to get it all assembled again. As usual it took longer than I thought it would due to some unforseen problems, hot weather and I managed to loose one of the valve keepers so that set me back a while untill I found another.
The tractor runs really well now. Later I will post a video.
I also installed the new drawbar I had made. It turned out great and is a much needed improvement over the old one.
Next I will need to get the correct steering, and a new set of fenders. The most important is a set of angle lugs so I can go use it along with some governor adjustments.
Powered by Kentico CMS for ASP.NET